Our Services
Concrete Repair Done Right
We specialize in three proven methods to fix sunken, uneven, and unstable concrete — without the cost and mess of full replacement.
Concrete Lifting
Raise sunken slabs back to their original position
Over time, soil beneath concrete slabs erodes, compacts, or washes away — leaving the slab unsupported and sunken. Our polyurethane foam injection lifts the slab back to grade quickly and with minimal disruption.
How It Works
Drill small ports
We drill dime-sized holes through the slab at strategic locations.
Inject expanding foam
High-density polyurethane foam is injected beneath the slab, expanding to fill voids and lift the concrete.
Patch and finish
Ports are patched flush. The slab is walkable within 15 minutes.
Key Benefits
- Costs 50–70% less than full replacement
- Walkable in 15 minutes
- Minimal disruption to landscaping
- Waterproof, lightweight foam won't re-sink
Ideal For
Driveways, sidewalks, patios, garage floors, steps, and commercial spaces where there is installed equipment.
Concrete Leveling
Eliminate trip hazards and uneven surfaces
Uneven concrete isn't just an eyesore — it's a LIABILITY. Whether caused by frost heave or settling soil, we lift low spots to create a smooth, level surface.
How It Works
Assess the surface
We measure the elevation difference across the affected area to determine the best approach.
Lift
Low sections are raised with foam injection.
Verify and patch drilled holes
We verify level across the joint then fill the drilled holes to an almost invisible finish.
Key Benefits
- Eliminates trip hazards
- Restores ADA compliance on walkways
- Prevents water pooling near foundations
- Same-day service in most cases
Ideal For
Sidewalks, entryways, commercial walkways, parking lots, and interior floors
Void Filling
Prevent collapse before it becomes a sinkhole
We use FillFoam™ — a lightweight, fast, and cost-effective solution that prevents collapse and the formation of cavities that could develop into future sinkholes. FillFoam fills voids completely, bonding to surrounding soil and the underside of your slab for a permanent, waterproof fix.
How It Works
Locate the void
We probe and inspect to map the full extent of the void beneath the slab or structure.
Inject FillFoam™
FillFoam is injected to completely fill the void, expanding to bond with the soil and the underside of the slab.
Confirm fill & patch
We verify complete fill and patch all injection ports flush with the surface.
Key Benefits
- Prevents future sinking, cracking & sinkholes
- Lightweight — won't add load to weak soil
- Waterproof and rot-resistant
- Works in mines, culverts, tunnels, tanks, wells, pipes, seawalls, crawl spaces & more
Ideal For
Mines & shafts, culverts, tunnels, tanks, wells, sinkholes, pipes, seawalls, crawl spaces, and foundation backfill
The Method
Why Polyurethane Foam?
Not all concrete repair methods are equal. Here's why foam injection outperforms the alternatives.
| Factor | Foam Injection | Mudjacking | Full Replacement |
|---|---|---|---|
| Cost vs. replacement | 50–70% less expensive | 30–50% less expensive | Most expensive |
| Cure time | 15 minutes | 24–48 hours | 7–10 days |
| Weight added | Very light — 2 lbs/cu ft | Heavy — 100 lbs/cu ft | Heavy |
| Longevity | Permanent — won't erode | May re-sink over time | Permanent if done right |
| Disruption | Minimal — small ports only | Larger holes, messier | Full demolition |
Not Sure Which Service You Need?
That's what we're here for. Send us a few photos and we'll tell you exactly what's going on — no obligation.